Allied-telesis AT-S62 Manual do Utilizador descarregar pdf (Página 141)

100

101

AT-S62 Menus Interface User’s Guide

Section I: Basic Operations 141

Enter Priority [0x1 - 0xFFFF]: [0x1 to 0xffff] -> 0x

5. Enter the new value is hexadecimal. The range is 1 to FFFF. The lower

the value, the higher the priority. The prefix “0x” indicates that the

number is hexadecimal.

The new priority value takes effect immediately on the switch.

6. After making changes, type R until you return to the Main Menu. Then

type S to select Save Configuration Changes.

Creating an

Aggregator

To create an aggregator, perform the following procedure:

Caution

Do not connect the cables to the ports of the aggregator on the

switch until after you have configured the aggregator with the

management software and enabled LACP. Connecting the cables

before configuring the software and activating the protocol will

create a loop in your network topology. Data loops can result in

broadcast storms and poor network performance.

Note

Before creating an aggregator, verify that the ports that will be

members of the aggregator are set to Auto-Negotiation or 100

Mbps, full-duplex. Aggregate trunks do not support half-duplex

mode.

1. From the Main Menu, type 1 to select Port Configuration.

2. From the Port Configuration menu, type 4 to select Port Trunking and

LACP.

The Port Trunking and LACP menu is shown in Figure 36 on page 134.

3. Type 2 to select LACP Configuration.

The LACP (IEEE 8023ad) Configuration menu is shown in Figure 39 on

page 140.

4. Type 3 to select Create Aggregator.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 759 760

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S62 Manual do Utilizador Página 141

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S62