Allied Telesis AT-iMG606BD Especificações descarregar pdf (Página 467)

100

101

13. Configuring Network Services Creating Network VLANs

458

AlliedView NMS Administration Guide

When the Physical Links table is the active panel, the Link menu pull-down appears and the following options are available:

• Managed Object Properties - The base properties of the physical link.

• Alarms/Events - This will invoke the Fault Management tables for Alarms and Events on the selected link.

• Manage/UnManage - The link may be set to unmanaged to indicate that it is not a real link, but rather a modelled link. The

color of the link will be gray and the link will not change status based on alarms.

Note: As mentioned in 13.2.3, when creating a model physical link (does not actually exist), it is recommended to go to the Physical

Links table in Network Inventory and UnManage that link. Doing this will unmanage any associated model VLAN links.

• Update Status - The AlliedView NMS checks the alarm database for its status. The status is updated automatically, so this

update status request should not be necessary for links.

13.2.6 Alarm Indicators from the Maps and Inventory Tables

When there is an alarm condition for any component in the network VLAN configuration, the following categories of alarms

may be raised:

• Port

• VLAN IF

• Link

• Discovery

• Topology

For any component in any map or table, right-clicking the component brings up the Network Events or Alarms table for only

that component and the condition can be examined more closely.

13.3 Creating Network VLANs

From the Physical Network map, a Network VLAN can be created using a GUI wizard that goes through all of the steps to

create all of the needed components.

Note: The user can also highlight a VLAN that already exists in the VLAN Network node and right click; all of the VLAN tasks are

accessible.

13.3.1 Creating Initial VLAN Information

To create a network VLAN, select one or more nodes on the Physical Network map. This can be done by clicking one node,

and then holding down the Shift key while selecting other nodes. Links between nodes can be selected as well. Select Network

Services -> VLAN -> Create VLAN from the pull-down menu, or right-click one of the nodes. The Create VLAN Net form will

appear, as shown in Figure 13-9. The form will be pre-populated with the selected nodes and links. Table 13-4 shows the

options available.

1 2 ... 462 463 464 465 466 467 468 469 470 471 472 ... 994 995

Comentários a estes Manuais

Sem comentários

Allied Telesis AT-iMG606BD Especificações Página 467

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores Allied Telesis AT-iMG606BD