Allied-telesis AT-S60 Manual do Utilizador descarregar pdf (Página 596)

Chapter 30: Basic Switch Parameters

Section VI: Web Browser Management 596

The SNMP Tab is shown in Figure 195.

Figure 195 Configuration System Page, SNMP Tab

3. To enable SNMP Access for the SNMPv1 and SNMPv2c protocols, click

the box next to Enable SNMP Access.

Use this parameter to enable the switch to be remotely managed

with an SNMP application program.

If the check box in the Enable SNMP Access box is empty, the switch

cannot be managed through SNMP. This is the default.

4. To enable authentication failure traps to be sent, click the box next to

Enable Authentication Failure Trap.

When this field is selected and the switch receives an

unauthenticated request, an authentication failure trap is sent to

the trap receivers configured on the switch.

5. Click Apply to update the SNMP Tab.

Sem comentários

Allied-telesis AT-S60 Manual do Utilizador Página 596