Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 141)

100

101

AT-S63 Management Software Command Line Interface User’s Guide

Section I: Basic Operations 141

SHOW INTERFACE

Syntax

show interface[=

port

]

Parameter

port Specifies the port whose interface information you want

to display. You can specify more than one port at a

time. You can specify the ports individually (for

example, 5,7,22), as a range (for example, 18-23), or

both (for example, 1,5,14-22). All ports are displayed if

you omit the port number.

Description

This command displays the contents of the interface MIB for a specific

port. An example of the information displayed by this command is shown

in Figure 10.

Figure 10. SHOW INTERFACE Command

This command provides the following information about a port:

 ifIndex - The index of the interface in the interface table.

 ifMTU - The size, in octets, of the largest packet that can be

transmitted on the port.

 ifSpeed - An estimate of the port’s current bandwidth, in bits per

second. This MIB object is zero (0) when the port does not have a link

to an end node.

 ifAdminStatus - The configured state of the port, one of the following:

Up - The port is up.

Down - The port is down.

 ifOperStatus - The current operational status of the port, one of the

following:

Up - A valid link exists between the port and the end node.

ifIndex.............................. 1

ifMtu................................ 9198

ifSpeed.............................. 100000000

ifAdminStatus........................ Up

ifOperStatus......................... Up

ifLinkUpDownTrapEnable............... Enabled

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 679 680

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 141

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63