Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 219)

100

101

AT-S63 Management Software Command Line Interface User’s Guide

Section II: Advanced Operations 219

SET CONFIG

Syntax

set config=[cflash:]

filename

.cfg|none

Parameter

config Specifies the name of the configuration file to act as the

active configuration file for the switch. The name can be

from 1 to 16 alphanumeric characters, not including the

extension “.cfg”. If the filename contains spaces,

enclose it in double quotes.

Description

This command changes the active configuration file on a switch. The

switch uses the active configuration file to configure its parameter settings

when reset or power cycled. The switch also updates the active boot

configuration file whenever you issue the SAVE CONFIGURATION

command.

Before using this command, note the following:

 To view the name of the currently active configuration file, see “SHOW

CONFIG” on page 222.

 The configuration file must already exist. To view the files, see “SHOW

FILE” on page 223. Configuration files have a “.cfg” extension. To

create an entirely new configuration file, refer to “CREATE CONFIG”

on page 212.

 Changing the active boot configuration file does not change the current

operating configuration of the switch. If you want the switch to

reconfigure itself according to the configuration in the newly assigned

active boot configuration file, reset or power cycle the switch.

 Entering the SAVE CONFIGURATION command after changing the

active configuration file overwrites the settings in the file with the

current operating settings of the switch.

 Specifying the NONE option causes the switch to operate without an

active configuration file. The switch does not allow you to save any

further configuration changes with the SAVE CONFIGURATION

command after the NONE option is specified. If you reset the switch, it

uses the BOOT.CFG configuration file to configure its settings.

However, you can still use the CREATE CONFIG command to save

the configuration to a new configuration file.

 You can specify a configuration file on a flash memory card for those

systems that support the card. However, the switch does not copy the

configuration file to its file system, but instead uses and updates the

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 679 680

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 219

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63