Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 498)

100

101

Chapter 28: Multiple Spanning Tree Protocol Commands

498 Section V: Spanning Tree Protocols

SET MSTP

Syntax

set mstp [default]

[forceversion=stpcompatible|forcestpcompatible|

normalmstp] [hellotime=

hellotime

]

[forwarddelay=

forwarddelay

] [maxage=

maxage

]

[maxhops=

maxhops

] [configname="

name

[revisionlevel=

number

]

Parameters

default Disables MSTP and returns all bridge and port MSTP

settings to the default values. This parameter cannot be

used with any other parameter. (This parameter

performs the same function as the PURGE MSTP

command.) The spanning tree protocol must be

disabled to use this parameter.

forceversion Controls whether the bridge will operate with MSTP or

in an STP-compatible mode. If you select MSTP, the

bridge will operate all ports in MSTP, except for those

ports that receive STP or RSTP BPDU packets. If you

select STP Compatible or Force STP Compatible, the

bridge uses its MSTP parameter settings, but sends

only STP BPDU packets from the ports

The options are:

stpcompatible or The bridge uses the MSTP

forcestpcompatible parameter settings, but transmits

only STP BPDU packets from the

ports. These options are

equivalent.

normalmspt The bridge uses MSTP. The

bridge sends out MSTP BPDU

packets from all ports except for

those ports connected to bridges

running STP. This is the default

setting.

hellotime Specifies the time interval between generating and

sending configuration messages by the bridge. This

parameter can be from 1 to 10 seconds. The default is 2

seconds.

1 2 ... 493 494 495 496 497 498 499 500 501 502 503 ... 679 680

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 498

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63