Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 466)

100

101

Chapter 26: Spanning Tree Protocol Commands

466 Section V: Spanning Tree Protocols

SET STP

Syntax

set stp [default] [priority=

priority

] [hellotime=

hellotime

]

[forwarddelay=

forwarddelay

] [maxage=

maxage

]

Parameters

default Disables STP and returns all bridge and port STP

settings to the default values. This parameter cannot be

used with any other command parameter and can only

be used when STP is disabled. (This parameter

performs the same function as the PURGE STP

command.)

priority Specifies the priority number for the bridge. This

number is used in determining the root bridge for STP.

The bridge with the lowest priority number is selected

as the root bridge. If two or more bridges have the

same priority value, the bridge with the numerically

lowest MAC address becomes the root bridge.

The range is 0 to 61,440 in increments of 4,096. The

range is divided into sixteen increments, as shown in

Table 12. You specify the increment that represents the

desired bridge priority value. The default value is

32,768 (increment 8).

Table 12. Bridge Priority Value Increments

Increment

Bridge

Priority

Increment

Bridge

Priority

00832768

1 4096 9 36864

2 8192 10 40960

3 12288 11 45056

4 16384 12 49152

5 20480 13 53248

6 24576 14 57344

7 28672 15 61440

1 2 ... 461 462 463 464 465 466 467 468 469 470 471 ... 679 680

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 466

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63