Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 131)

AT-S79 Management Software User’s Guide

Section I: Using the Menus Interface 131

Modifying an

SNMP

Community

Use the following procedure to modify an existing SNMP community.

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 28 on

page 128.

2. From the Basic Switch Configuration Menu, type N to select SNMP

Configuration.

The SNMP Configuration Menu is shown in Figure 29 on page 129.

3. Type M to select Modify Community Entry.

The following prompt is displayed:

Enter entry number>

a. Enter the entry number (from 1 through 8) that you want to modify.

Then press Enter.

The following prompt is displayed:

Choose which to be modified (A/C/B)?

Note

In the above prompt, A represents access level, C represents

community name, and B represents both the access level and

community name.

b. Select A to modify the access level of a community.

The following prompt is displayed:

Enter community access (R/W)>

c. Enter R to indicate Read-Only access and W to indicate Read-

Write access.

The Community Configuration Menu is updated with the new access

level.

4. Select C to change the community name.

The following prompt is displayed:

Enter entry number>

a. Enter a number from 1 through 8.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 347 348

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 131