Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 85)

AT-S79 Management Software User’s Guide

Section I: Using the Menus Interface 85

Creating a Static Multicast Address

The procedures in this section describe how to create, delete, and modify

static multicast addresses. See the following procedures:

 “Adding a Static Multicast Address” on page 85

 “Deleting a Static Group” on page 86

 “Deleting a Static Member Port” on page 87

Adding a Static

Multicast

Address

To assign a static multicast address or to assign a group number to an

existing group MAC address, perform the following procedure:

1. From the Main Menu, type A to select Advanced Switch

Configuration.

The Advanced Switch Configuration Menu is shown in Figure 16 on

page 70.

2. From the Advanced Switch Configuration Menu, type A to select Static

Multicast Address Configuration.

The Static Multicast Address Table Menu is shown in Figure 20.

Figure 20. Static Multicast Address Table Menu

3. Type A to select Add Static Member Port.

Advanced Switch Configuration -> Static Multicast Address Table Menu

Group MAC Address Group Members

----------------- --------------------------------------------

01:00:5E:00:01:00 1

01:00:5E:00:01:01 2

01:00:5E:00:01:02 3, 4,5,6

01:00:5E:00:01:03 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18

01:00:5E:00:01:04 19, 20

01:00:5E:00:01:05 21

01:00:5E:00:01:06 22

-------------------------------<COMMAND>------------------------------

[N}ext Page [A]dd Static Member Port Delete Static [G]roup

[P]revious Page [D]elete Static Member Port [Q]uit to previous menu

Command>

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 347 348

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 85