Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 34)

Chapter 3: Basic Switch Parameters

34 Section I: Using the Menus Interface

Configuring the IP Address, Subnet Mask, and Gateway Address

This procedure explains how to manually assign an IP address, subnet

mask, and gateway address to the switch. Before performing the

procedure, note the following:

 An IP address and subnet mask are not required for normal network

operations of the switch. Values for these parameters are only required

if you want to remotely manage the device with a web browser.

 A gateway address is only required if you want to remotely manage

the device from a remote management station that is separated from

the switch by a router.

 To configure the switch to automatically obtain its IP configuration from

a DHCP server on your network, go to “Enabling and Disabling the

DHCP Client” on page 37.

To set the switch’s IP configuration, perform the following procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 4.

Figure 4. Basic Switch Configuration Menu

Main Menu -> Basic Switch Configuration Menu

System [A]dministration Configuration

System [I]P Configuration

S[N]MP Configuration

[P]ort Configuration

[U]ser Interface Configuration

Rapid [S]panning Tree Configuration

[B]andwidth Control Configuration

IP Access [L]ist

Destination MAC [F]ilter

[Q]uit to previous menu

Command>

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 347 348

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 34