Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 338)

Chapter 37: Management Software Updates

338 Section II: Using the Web Browser Interface

Upgrading a Firmware Image Using HTTP

Before downloading a new version of the AT-S79 management software

onto the switch with HTTP, note the following:

 The current configuration of a switch is retained when a new AT-S79

software image is installed. To return a switch to its default

configuration values, refer to “Returning the AT-S79 Management

Software to the Factory Default Values” on page 53.

 On the switch that you are downloading the new image file to, assign

an IP address and subnet mask. For instructions on how to set the IP

address on a switch, refer to “Configuring the IP Address, Subnet

Mask, and Gateway Address” on page 34 or “Enabling and Disabling

the DHCP Client” on page 37.

Caution

Downloading a new version of management software onto the

switch causes the device to reset. Some network traffic may be lost

during the reset process.

This procedure assumes that you have already obtained the software and

have stored it on the computer from which you will be performing this

procedure.

To download the AT-S79 image software onto the switch using HTTP,

perform the following procedure:

1. From the Tools folder, select the Firmware Upgrade folder.

2. From the Firmware Upgrade folder, select via HTTP.

Figure 101. Firmware Upgrade via HTTP Page

1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 347 348

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 338