Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 245)

AT-S79 Management Software User’s Guide

Section II: Using the Web Browser Interface 245

Returning the AT-S79 Management Software to the Factory Default

Values

This procedure returns all AT-S79 management software parameters to

their default values and deletes all tagged and port-based VLANs on the

switch. The AT-S79 management software default values are listed in

Appendix A, “AT-S79 Software Default Settings” on page 341.

Caution

This procedure causes the switch to reboot. The switch does not

forward network traffic during the reboot process. Some network

traffic may be lost.

To return the AT-S79 management software to the default settings,

perform the following procedure:

1. From the Tools folder, select Reboot.

The Reboot page is shown in Figure 65 on page 241.

2. For the Reboot Type, select one of the following:

Reset to Factory Default

Resets all switch parameters to the factory default settings, including

IP address, subnet mask, and gateway address.

Reset to Factory Default Except IP Address

Resets all switch parameters to the factory default settings, but retains

the IP address, subnet mask, and gateway settings. If the DHCP client

is enabled, it remains enabled after this reset.

3. For the Reboot Status, select Start to start the reboot.

4. Click Apply.

The switch is rebooted. You must wait for the switch to complete the

reboot process before reestablishing your management session.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 347 348

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 245