Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 254)

100

101

Chapter 23: Port Trunking

254 Section II: Using the Web Browser Interface

Modifying a Port Trunk

This procedure adds and removes ports from a port trunk.

Caution

Before you modify a port trunk, disconnect the cables from the ports

of the trunk. Adding or removing ports from a trunk without first

disconnecting the cables can create loops in your network topology,

which can cause broadcast storms and poor network performance.

To add or remove ports from a trunk, perform the following procedure:

1. From the Bridge folder, select Spanning Tree.

2. From the Spanning Tree folder, select Trunking.

The Trunking page is shown in Figure 69 on page 252.

3. Click the status of the port trunk to be modified and change the status

from Enable to Disable.

4. Click Apply.

5. To add or remove a port from a trunk, click the dialog box for the port

in the corresponding trunk row. A check in a box indicates the port is a

member of the trunk. No check means the port is not a member.A port

trunk can contain up to eight ports.

6. Click Apply.

7. Modify the port trunk on the other switch and reconnect the cables.

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 347 348

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 254

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S79