Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 139)

AT-S79 Management Software User’s Guide

Section I: Using the Menus Interface 139

d. Enter a previously defined community name followed by Enter. See

“Adding an SNMP Community” on page 128.

The Trap Receiver Configuration Menu is redrawn with the new trap

displayed.

5. Type Q to select Quit to previous menu and save your changes.

Deleting a Trap

Receiver

To delete a trap receiver, perform the following procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 28 on page

128.

2. From the Basic Switch Configuration Menu, type N to select SNMP

Configuration.

The SNMP Configuration Menu is shown in Figure 29 on page 129.

3. From the SNMP Configuration Menu, type T to select Trap Receiver

Configuration Menu.

The Trap Receiver Configuration Menu is displayed in Figure 31 on

page 133.

4. Type D to select Delete Trap Receiver.

The following prompt is displayed:

Enter entry number>

a. Enter a trap number between 1 and 10. Then press Enter.

The Trap Receiver Configuration Menu is updated.

5. Type Q to select Quit to previous menu and save your changes.

Modifying a Trap

Receiver

To modify a trap receiver, perform the following procedure: