Allied-telesis AT-S99 Manual do Utilizador descarregar pdf (Página 136)

Chapter 5: Configuring AT-CM and AT-CV Media Converter Line Cards

136

Displaying the Parameter Settings on AT-CM Line Cards

Menus To view the current parameter settings of the AT-CM Line Cards from the

menus:

1. From the Main Menu, select Module Status and Configuration to

display the Module Status and Configuration menu shown in Figure 48

on page 128.

2. From the Module Status and Configuration menu, select the AT-CM

Line Card you want to view. You can view only one line card at a time.

The Module Configuration Menu in Figure 53 on page 139 is

displayed.

3. Select Line Card Configuration to display the menu in Figure 62 on

page 153.

4. Select Display Current Configuration. An example of the window is

shown in Figure 51.

Figure 51. Display Current Configuration Window

Display Current Configuration

Slot: 11 Module: AT-CM202-v2

Operational Mode: OAM Visible

Port A(100BaseFX) Port B(100Base-TX)

Port Enable: Enabled Disabled

Negotiation: -- Manual negotiate

Duplex: -- Half

MDI/MDIX: -- MDI

Flow Control Enable Enable

Ingress Rate Limit: No Limit No Limit

Egress Rate Limit: No Limit No Limit

OAM Configuration

Admin State: Enabled

Mode: Active

Maximum OAMPDU Size: 64

Unidirectional Support: Yes

Loopback Support: Yes

Event Support: Yes

Variable Retrieval Support: Yes

Return to Line Card Configuration...

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 319 320

Sem comentários

Allied-telesis AT-S99 Manual do Utilizador Página 136