Allied-telesis AT-S99 Manual do Utilizador descarregar pdf (Página 221)

AT-S73 and AT-S99 Management Software User’s Guide

221

Displaying OAM Information for Remote OAM Clients

The procedures in this section are used to view OAM status information on

remote OAM clients connected to local AT-CM Line Cards.

Note

These procedures require that the local and remote AT-CM Line

Cards be set to the OAM visible mode.

Menus To display status information for remote OAM clients from the menus:

1. From the Main Menu, select Module Status and Configuration to

display the Module Status and Configuration Menu, shown in Figure 48

on page 128.

2. Select the local card that is connected to the remote OAM device

whose status information you want to view. The Module Configuration

Menu is shown in Figure 53 on page 139.

3. Select Port A, the fiber optic port, to display the Port Management

Menu in Figure 54 on page 140. OAM is only supported on port A.

4. From the Port Management Menu, select OAM Configurations to

display the OAM Configuration Menu, shown in Figure 89 on page

204.

5. From the OAM Configuration Menu, select Show Remote OAM

Information to display the Show Remote OAM Information window,

shown in Figure 98.

Figure 98. Show Remote OAM Information Window

Show Remote OAM Information

Module 11, Port A

MAC Address 00:0c:46:9a:21:c9 Mux State Forward

Parser State Forward Local Discovering Yes

Local Stable No Remote Discovering No

Remote Stable No Critical Event No

Dying Gasp No Link Fault No

OAM Version 0x01 Config Revision 0x0003

Vendor Info 0x00160001 Vendor OUI 00-30-84

Mode Active Max OAMPDU Size 1518

Loopback Support Yes Event Support No

Variable Support Yes Unidirect Support Yes

Return to OAM Configurations ...

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 319 320

Sem comentários

Allied-telesis AT-S99 Manual do Utilizador Página 221