Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 145)

Line Commands

Page 133

exec-timeout

The exec-timeout Line Configuration mode command sets the interval that the system waits until user input is

detected. Use the no form of this command to return to the default configuration.

Syntax

exec-timeout minutes [seconds]

no exec-timeout

Parameters

•

minutes — Specifies the number of minutes. (Range: 0 - 65535)

• seconds — Specifies additional time intervals in seconds. (Range: 0 - 59)

Default Configuration

The default configuration is 10 minutes.

Command Mode

Line Configuration mode

User Guidelines

To specify no timeout, enter the exec-timeout 0 command.

Example

The following example configures the interval that the system waits until user input is detected to 20 minutes.

history

The history Line Configuration mode command enables the command history function. Use the no form of this

command to disable the command history function.

Syntax

history

no history

Default Configuration

The command history function is enabled.

Command Mode

Line Configuration mode

User Guidelines

This command enables the command history function for a specified line. To enable or disable the command

history function for the current terminal session, use the terminal history user EXEC mode command.

Console(config)#

line console

Console(config-line)#

exec-timeout

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 347 348

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 145