Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 302)

Page 290

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example adds VLANs 1, 2, 5 to 6 to the allowed list of Ethernet port 1/g16.

switchport trunk native vlan

The switchport trunk native vlan Interface Configuration mode command defines the native VLAN when the

interface is in trunk mode. Use the no form of this command to return to the default configuration.

Syntax

switchport trunk native vlan vlan-id

no switchport trunk native vlan

Parameters

•

vlan-id— Specifies the ID of the native VLAN.

Default Configuration

VID=1.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

The command adds the port as a member in the VLAN. If the port is already a member in the VLAN (not as a

native), it should be first removed from the VLAN.

Example

The following example configures VLAN number 123 as the native VLAN when Ethernet port 1/g16 is in trunk

mode.

switchport general allowed vlan

The switchport general allowed vlan Interface Configuration mode command adds or removes VLANs from a

general port.

Console(config)# interface ethernet 1/g16

console(config-if)# switchport trunk allowed vlan add 1-2,5-6

Console(config)# interface ethernet 1/g16

Console(config-if)# switchport trunk native vlan 123

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 347 348

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 302