Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 224)

Page 212

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

User Guidelines

There are no user guidelines for this command.

Example

The following example disables spanning-tree on Ethernet port 1/g5.

spanning-tree cost

The spanning-tree cost Interface Configuration mode command configures the spanning tree path cost for a

port. Use the no form of this command to return to the default configuration.

Syntax

spanning-tree cost cost

no spanning-tree cost

Parameters

•

cost — Path cost of the port (Range: 1 - 200,000,000)

Default Configuration

Default path cost is determined by port speed and path cost method (long or short) as shown below:

Command Modes

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

The path cost method is configured using the spanning-tree pathcost method Global Configuration mode

command.

Example

The following example configures the spanning-tree cost on Ethernet port 1/g15 to 35000.

Console(config)# interface ethernet 1/g5

Console(config-if)# spanning-tree disable

Interface Long Short

Port-channel 20,000 4

Gigabit Ethernet (1000 Mbps) 20,000 4

Fast Ethernet (100 Mbps) 200,000 19

Ethernet (10 Mbps) 2,000,000 100

Console(config)# interface ethernet 1/g15

Console(config-if)# spanning-tree cost 35000

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 347 348

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 224