Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 71)

Clock Commands

Page 59

sntp client enable (Interface)

The sntp client enable Interface Configuration (Ethernet, port-channel, VLAN) mode command enables the

Simple Network Time Protocol (SNTP) client on an interface. This applies to both receive Broadcast and Anycast

updates. Use the no form of this command to disable the SNTP client.

Syntax

sntp client enable

no sntp client enable

Default Configuration

The SNTP client is disabled on an interface.

Command Mode

Interface configuration (Ethernet, port-channel, VLAN) mode

User Guidelines

Use the sntp broadcast client enable Global Configuration mode command to enable Broadcast clients globally.

Use the sntp anycast client enable Global Configuration mode command to enable Anycast clients globally.

Example

The following example enables the SNTP client on Ethernet port 1/g3.

sntp unicast client enable

The sntp unicast client enable Global Configuration mode command enables the device to use the Simple

Network Time Protocol (SNTP) to request and accept SNTP traffic from servers. Use the no form of this command

to disable requesting and accepting SNTP traffic from servers.

Syntax

sntp unicast client enable

no sntp unicast client enable

Default Configuration

The SNTP Unicast client is disabled.

Command Mode

Global Configuration mode

User Guidelines

Use the sntp server Global Configuration mode command to define SNTP servers.

onsole(config)#

interface ethernet 1/g3

Console(config-if)#

sntp client enable

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 347 348

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 71