Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 120)

100

101

Chapter 7: Port Parameter Commands

120

SHOW INTERFACE

Syntax

show interface=

port

Parameter

port Specifies the port whose interface information you

want to display. You can specify more than one port at

a time. You can specify the ports individually (for

example, 5,7,22), as a range (for example, 18-23), or

both (for example, 1,5,14-22).

Description

This command displays the contents of the interface MIB for a specific

port and provides the following information:

❑ ifIndex - The index of the interface in the interface table.

❑ ifMTU - The size, in octets, of the largest packet that can be

transmitted on this port.

❑ ifSpeed - An estimate of the port’s current bandwidth, in pits per

second.

❑ ifAdminStatus - The configured state of the port, one of the

following:

up - The port is up.

down - The port is down.

❑ ifOperStatus - The current operational status of the port, one of

the following:

up - A valid link exists between the port and the end node.

down - The port and the end node have not established a link.

unknown - The port status is unknown.

❑ ifLinkUpDownTrapEnable - Whether or not link traps have been

enabled for the port, one of the following:

enabled - Link traps are enabled. To disable link traps, see

“DISABLE INTERFACE LINKTRAP” on page 105.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 463 464

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 120

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63