Allied-telesis AT-S94 CLI (AT-8000S Series) Manual do Utilizador descarregar pdf (Página 106)

100

101

Page 105

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Parameters

•

on — Force flow control as enabled.

• off — Force flow control as disabled.

• auto — Enable AUTO flow control configuration.

Default Configuration

Flow control is off.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

Negotiation should be enabled for flow control auto.

Example

In the following example, flow control is enabled on port 1/e5.

mdix

The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a given interface. Use

the no form of this command to disable cable crossover.

Syntax

mdix {on | auto}

no mdix

Parameters

•

on — Manual mdix

• auto — Automatic mdi/mdix

Default Configuration

The default setting is on.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

Auto: All possibilities to connect a PC with cross or normal cables are supported and are automatically detected.

On: It is possible to connect to a PC only with a normal cable and to connect to another device only with a cross

cable.

No: It is possible to connect to a PC only with a cross cable and to connect to another device only with a normal

cable.

console(config)#

interface ethernet

1/e5

console(config-if)#

flowcontrol on

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 401 402

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S94 CLI (AT-8000S Series) Manual do Utilizador Página 106

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S94 CLI (AT-8000S Series)