Allied-telesis AT-S94 CLI (AT-8000S Series) Manual do Utilizador descarregar pdf (Página 154)

Page 153

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Example

The following example configures a static entry in the IPv6 neighbor discovery cache.

show ipv6 neighbors

The show ipv6 neighbors Privileged EXEC mode command displays IPv6 neighbor discovery cache information.

Syntax

show ipv6 neighbors {static | dynamic}[ipv6-address ipv6-address] [mac-address mac-address] [ethernet

interface-number | vlan vlan-id | port-channel number]

Parameters

•

static — Displays static neighbor discovery cashe entries.

• dynamic — Displays dynamic neighbor discovery cashe entries.

• ipv6-address — Displays the neighbor discovery cache information entry of a specific IPv6 address.

• mac-address — Displays the neighbor discovery cache information entry of a specific MAC address.

• ethernet interface-number — Displays the neighbor discovery cache information entry of a specific Ethernet

port interface.

• vlan vlan-id — Displays the neighbor discovery cache information entry of a specific VLAN.

• port-channel number — Displays the neighbor discovery cache information entry of a specific Port-channel

number interface.

Default Configuration

This command has no default setting.

Command Mode

Privileged EXEC mode.

User Guidelines

•

The associated interface of a MAC address can be aged out from the FDB table, so that the Interface field

can be empty.

• When an ARP entry is associated with an IP interface that is defined on a port or port-channel, the VLAN field

is empty.

• The possible neighbor cache states are:

– INCMP (Incomplete) — Address resolution is being performed on the entry. Specifically, a Neighbor

Solicitation has been sent to the solicited-node multicast address of the target, but the corresponding

Neighbor Advertisement has not yet been received.

– REACH (Reachable) — Positive confirmation was received within the last ReachableTime milliseconds

that the forward path to the neighbor was functioning properly. While REACHABLE, no special action

takes place as packets are sent.

– STALE — More than ReachableTime milliseconds have elapsed since the last positive confirmation was

received that the forward path was functioning properly. While STALE, no action takes place until a

packet is sent.

– DELAY — More than ReachableTime milliseconds have elapsed since the last positive confirmation was

received that the forward path was functioning properly, and a packet was sent within the last

console(config)#

ipv6 neighbor

fe80::33 00:11:22:33:44:55 ethernet e5

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 401 402

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S94 CLI (AT-8000S Series) Manual do Utilizador Página 154

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S94 CLI (AT-8000S Series)